Denso BHT-202QW-CE Specifications download pdf (Page 106)

Chapter 2 Getting Started the BHT and System Menu

 Testing with Ping

Tapping the Ping tab on the NIC Control menu displays the screen

shown at left.

Dest IP: Specify the IP address of a host computer that

you want to ping.

Data size: Specify the data size of an echo request.

Interval: Specify the echo request intervals (in units of

100 ms).

Timeout: Specify the timeout period (in units of 100 ms)

for an echo request.

Type 1 or Type 2: Select the echo request send timing Type 1 or

Type 2 (described on the next page).

Count: Specify the number of echo requests to be sent.

To run Ping, tap the Ping Start button or press the ENT key.

Tapping the Ping Start button when the RF device is not opened automatically opens the RF device

and runs Ping.

Entry Range for Data size, Interval, Timeout, and Count

Item Allowable entry range Initial value

Data size

Interval

Timeout

Count

1 to 2048

0 to 65535

0* to 65535

* Specification of zero (0) will set the number of echo requests to be sent to "infinite," keeping sending

echo requests (until Ping is aborted).

If you specify a value out of the allowable entry range listed above, the nearest value within the range will

automatically apply.

After Ping runs, the screen shown at left appears.

Count: Number of echo requests sent

OK: Number of echo replies

NG: Number of errors found during execution of Ping

Timeout: Number of timeouts (for echo replies) that took

place during execution of Ping

RTT Ave. (ms): Echo reply time in milliseconds

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 173 174

No comments

Denso BHT-202QW-CE Specifications Page 106