Denso BHT-300B Specifications download pdf (Page 73)

Chapter 2 Getting Started the BHT and System Mode

[4.5] Setting the communications environments

After the BHT is initialized, the interface port and communications parameters are set as listed in the

default table below. Do not access them unless necessary.

Interface port Optical (IrDA interface port)

Communications protocol YMODEM

Communications parameters

for the IrDA interface port

Defaults

TRANSMIT SPEED 115200 bps

SERIAL No.: ON (Adds serial numbers to data

blocks.)

H. PARITY: ON (Adds a horizontal parity.)

LINKUP TIME: 30 seconds

PROTOCOL (Protocol options)

FIELD SPACE: Ignore (Trim)

Listed below are the default communications parameters for the direct-connect interface.

Communications parameters

for the direct-connect interface port

Defaults

TRANSMIT SPEED 115200 bps

PARITY BIT (Vertical parity) None

DATA BIT (Character length) 8 bits

STOP BIT (Stop bit length) 1 bit

SERIAL No.: ON (Adds serial numbers to data

blocks.)

H. PARITY: ON (Adds a horizontal parity.)

LINKUP TIME: 30 seconds

PROTOCOL (Protocol options)

FIELD SPACE: Ignore (Trim)

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 177 178

No comments

Denso BHT-300B Specifications Page 73