Denso AT10Q-SM User Manual download pdf (Page 33)

7.2 Editing Data

You can edit and output code data read, in any of the four data edit modes--"data extraction mode," "data substitution

mode," "data blocksorting mode" and "ADF script mode." These data edit modes can be selected with the

configuration software (ScannerSetting_2D). The default is "No editing."

Note: In the case of multi-line bar codes, unless all code ID marks read are matched, the data editing processing will

result in an error regardless of whether or not the data read contains any error. Whether the code ID mark is matched is

determined not by the combination of code ID marks but by Type 1 only (refer to Chapter 9, Section 9.4).

Note: In the case of split QR Code, the scanner in edit mode or batch edit mode performs data editing processing upon

completion of scanning of all split code symbols; in non-edit mode, it performs each time a single split code symbol is

read.

7.2.1 Data extraction mode

This mode offers three extraction choices--"data string," "data block" and "AI (Application Identifier)-prefixed string"

extractions from code data read and then outputs it.

The "data block" extraction is available only when code data is in the comma-delimited CSV format. The "AI-prefixed

string" extraction is available for EAN-128 (GS1-128), RSS (GS1 DataBar), and EAN.UCC Composite symbols

(excluding linear components in a UPC/EAN Composite symbol).

7.2.1.1 Extracting a data string

The scanner extracts a data string specified by the "Extraction start position" and "Extraction end position" from a

code specified by the "Code type" and then outputs it in the data transmission format selected in the scanner (see

Chapter 9, Section 9.4). The extraction conditions and extraction start and end positions are listed below.

 Extraction conditions

Extraction conditions Choices

Any code

QR Code

PDF417

Data Matrix

MaxiCode

UPC-A/EAN-13

UPC-E

EAN-8

Code 128

EAN-128 (GS1-128)

Codabar (NW-7)

Code 39

Code 93

Interleaved 2of5 (ITF)

RSS (GS1 DataBar)

"Code type"

EAN.UCC Composite symbology

"Data transfer regardless of error result" Permit/Prohibit

If the scanner fails to extract a data string or scans a code not specified by "Code type" when the "Data transfer

regardless of error result" is permitted, then it outputs the data read as is without editing.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 112 113

No comments

Denso AT10Q-SM User Manual Page 33