Denso RC5 Specifications download pdf (Page 45)

2.4.5 User Output Commands

There are three types of user output commands, SET, RESET and OUT. The SET and

RESET commands turn ON and OFF all user outputs specified by I/O type variables.

The OUT command outputs data to a specified user output.

• SET Command

The SET command turns ON all user outputs specified by I/O type variables.

For further information about the SET command, refer to the PROGRAMMER'S

MANUAL (I), Chapter 13, Section 13.1 "SET."

• RESET Command

The RESET command turns OFF all user outputs specified by I/O type variables.

For further information about the RESET command, refer to the PROGRAMMER'S

MANUAL (I), Chapter 13, Section 13.1 "RESET."

• OUT Command

The OUT command outputs data to the user output specified by an I/O type variable.

For further information about the OUT command, refer to the PROGRAMMER'S

MANUAL (I), Chapter 13, Section 13.1 "OUT."

2.4.6 Note When Using Input Signals

When using an input signal (e.g. IO[34]) as a trigger signal to check the state of another

input signal (e.g. IO [35]) as shown in the example below, the data (e.g. IO[34]) should

be set at least 1 msec before.

NOTE: See also Chapter 3, Subsection 5.2.1 "General Information about Processing"

and Chapter 4, Subsection 4.2 "Operation Preparation Start (Input)" for related

explanations.

When there is chattering in the input signal (e.g. relay contact), the length of A should

be made longer.

Important Note When Using Input Signals

1 msec or more

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 181 182

No comments

Denso RC5 Specifications Page 45