113
Step 5
Remove the panel fastening screw and then the panel hole blank cap.
To mount the µVision board, remove the lower blank cap.
To mount the Ethernet board or DeviceNet boards, remove the upper or the middle
blank cap.
Step 6
To mount the
Vision board to the robot controller
RC5-VM6A
, remove the
screws from the extension board retaining strut and take off the strut.
If you do not mount the µVision board, skip to Step 8.
Required only
for the robot
controller
(RC5-VM6A)
designed for
the VM-6070D.
Comments to this Manuals